3. Settings and routine maintenance

Specifications

The recommended lubricants and liquids

The lubricants and liquids recommended for use of cars by the company manufacturer at the time of drawing up the present manual are listed below. Fresher information can be obtained at company car repair shops of the Nissan company.


Type and properties of working liquids

 


Fuel Unleaded gasoline is not worse than AI95
Motive oil:
Type Universal engine oil for petrol engines certified on API
Viscosity See the card of vyazkost on an illustration
Transmission liquid for AT Nissan-Matic "D" ATF
Gearbox oil for RKPP API GL-4 80W-90 gearbox oil
Brake fluid DOT 3
Liquid of system of hydrostrengthening of a wheel ATF DEXRON III
Lubricant for wheel bearings Lithium NLGI lubricant No. 2
Cooling liquid (50 ÷ 70) % antifreeze solution on the basis of ethylene glycol with water
Volumes of working liquids, l *
Capacity of the fuel tank 70
Motive oil (including an oil filter)
Models 1993 and 1994 of of the issue. 3.9
Models since 1995 of the issue. 4.0
Cooling liquid
Models 1993 and 1994 of of the issue. 8.27
Models since 1995 of the issue. 8.5
Transmission liquid for AT In the best way of determination of quantity, necessary at change of ATF, is fresher than liquid measurement of volume of ATF merged from transmission is
Gearbox oil for RKPP
Models 1993 and 1994 of of the issue. 4.2 - 4.5
Models since 1995 of the issue. 4.5 - 4.8
All volumes are specified only approximately. At adjustment be verified with-level tags.
System of ignition
Spark plugs:
Models 1993 and 1994 of of the issue.
Type NGK BKR5ES-11, or equivalent to them on performance data
Interelectrode gap, mm 1.0 - 1.1
Models since 1995 of the issue.
Type NGK PFR5G-11, or equivalent to them on performance data
Interelectrode gap, mm 1.1
Resistance of candle wires, Ohm/dm Not higher than 3033
Ignition order 1-2-3-4-5-6

The scheme of an arrangement of cylinders and the direction of rotation of the distributor of ignition (only models 1993 and 1994 of of the issue - on models since 1995 the issue is used system of ignition without distributor)

Adjustment of valvate gaps on the cold engine (model since 1995 of the issue)
Inlet valves, mm 0.254 - 0.330
Final valves 0.279 - 0.381
Brake system
Minimum admissible thickness of frictional overlays of blocks of disk brake mechanisms, mm 1.59
Adjustment of the parking brake 10 - 11 clicks of a ratchet
Suspension bracket and steering
Maximum admissible side play of a steering wheel, mm 30.16
Admissible weak point of landing of spherical support, mm 0
Efforts of tightening of threaded connections Nanometer
Drain stopper of a case of AT 29.8 - 39.3
Bolts of fastening of the pallet of a case of AT 7.0 - 8.9
Drain stopper of a case of the engine 29.8 - 39.3
Drain stopper of a case of RKPP 24.4 - 33.9
Spark plugs 18.9 - 29.8
Nuts of fastening of wheels 97.6 - 118.0

The scheme of an arrangement of components in a motive compartment of the car (the model of 1995 of the issue is shown)

1 — the PCV Valve
2 — Spark plugs (under covers)
3 — the Fuel filter
4 — the Tank of brake fluid
5 — an air cleaner Casing
6 — the Rechargeable battery
7 — the Assembly block of safety locks
8 — the Assembly block of the relay 2

9 — the Probe of measurement of the ATF level
10 — the Probe of measurement of level of motive oil
11 — a radiator Cover
12 — the Broad tank of the cooling system
13 — the Tank of liquid of washing of a windshield
14 — the Cover of a jellied mouth of motive oil
15 — the Tank of liquid of system of hydrostrengthening of a wheel
16 — the Assembly block of the relay 1


The bottom view on a car front

1 — the air conditioner Compressor
2 — Nizhny Novgorod a radiator hose
3 — the Drain stopper of a radiator
4 — ATF discharge Stopper
5 — the Lower spherical support

6 — Protective covers of CV JOINTS of a power shaft
7 — Section of system of production of the fulfilled gases
8 — the Drain stopper of the pallet of a case
engine
9 — the Support of the brake mechanism


The typical bottom view on a car back

1 — Section of system of production of the fulfilled gases
2 — the Muffler
3 — the Fuel tank
4 — the Rack of a back suspension bracket

5 — Zadny Bridge
6 — the Cross bar of the back bridge
7 — the Disk brake mechanism of a back wheel
8 — the Longitudinal lever of a back suspension bracket